I'm getting an error when I try to do the peak fitting with the XRF data. I opened a coarse map and went through the blurring steps. I then created a mask around a hot spot, selected MCA in the popup window, and that opened the XRF spectrum. I changed the view to log scale. I opened View Config, checked the elements that are selected (using default at the moment), then clicked Fit Current. When I click Fit Current I get the following error:
Any ideas on how to fix are appreciated! Thank you! Also I'm using version 3.09!
You'll want to check your configuration... This usually happens when the default detector material is not set (its just a "--") and it should be a valid element, like "Si". This is found on the tabs after the detection elements and is in the materials parameters region of the fitting configuration.